Ram 2500 and 3500 · Elgin CDJR · Streamwood, IL
Ram 2500/3500 Air Suspension Guide
The air suspension available on the 2026 Ram 2500 and 3500 is a rear leveling system that keeps the back of the truck level as the load changes. Here is how its two ride heights and its special modes work, what the lights mean and how to use it when towing, from the 2026 Ram 2500/3500 owner's manual.

The short answer
The 2026 Ram 2500/3500 owner's manual describes the air suspension (if equipped) as a rear leveling ride height system whose main purpose is to keep the truck's rear ride height level. You choose between Normal Ride Height for everyday driving and Alternate Trailer Height, which lowers the truck about 1 inch (25 mm) for a level truck while towing. Service Mode and Bed Lowering Mode switch off automatic leveling for jobs like changing a tire, loading the bed or hooking up a trailer. The system needs the ignition in ON/RUN or the engine running.
Normal Ride Height vs Alternate Trailer Height
| Setting | What the manual says |
|---|---|
| Normal Ride Height (NRH) | The standard position of the suspension, meant for normal driving. It automatically adjusts to maintain the rear ride height as conditions change. |
| Alternate Trailer Height (ATH) | Lowers the vehicle approximately 1 inch (25 mm) for a level truck, to be used as required while trailer towing. It also automatically adjusts to maintain the rear ride height as conditions change. |
| Lightly loaded 3500 | If lightly loaded, 3500 models will lower as close to 1 inch (25 mm) as possible. Most 3500 models will not lower to Alternate Trailer Height when unloaded. |
The manual says the system requires the ignition in the ON/RUN position or the engine running. After the truck is turned off, it keeps load leveling for 5 minutes without compressor activation, so a trailer or a load can be removed while the ride height holds. After 5 minutes, turn the ignition to ON/RUN so the suspension can re-level for the load you added or removed.
From the 2026 Ram 2500/3500 Owner's Manual, Air Suspension — Description (p. 181), read November 17, 2026.
Service Mode, Bed Lowering Mode and Protection Strategy
| Mode | What it is for | How it ends |
|---|---|---|
| Service Mode | Disables automatic leveling to assist with changing a tire. | Driving the vehicle, or deselecting the mode in the settings. No indicator lamps are lit in this mode. |
| Bed Lowering Mode | At zero vehicle speed, lowers the rear suspension to the lowest possible height and disables the air suspension, for easier loading and unloading of the truck and easier trailer hook-up. | Driving the vehicle, deselecting the mode, or pushing the Alternate Trailer Height button. A telltale on the cluster is lit in this mode. |
| Protection Strategy | The truck disables load leveling as required to protect the system, for example if the suspension is overloaded or battery charge is low. | Load leveling resumes automatically as soon as system operation requirements are met. See an authorized dealer if it does not resume. |
If you disable the system with the settings menu (Service Mode or Bed Lowering Mode), the manual says it stays disabled when the truck is turned off. Reactivate it from the settings menu or by driving above 5 mph (8 km/h).
From the 2026 Ram 2500/3500 Owner's Manual, Air Suspension — Description and Air Suspension Modes (pp. 181-182), read November 17, 2026.
How to use the Alternate Trailer Height button
- With the truck at Normal Ride Height, push the Alternate Trailer Height (ATH) button once. The truck lowers to Alternate Trailer Height and the button LED illuminates.
- The LED blinks continuously until Alternate Trailer Height has been reached, then stays on.
- Push the ATH button again to raise the truck back to Normal Ride Height. The LED blinks until the ride height is reached, then turns off.
The Uconnect Settings include a Suspension menu with options for ride height, whether the horn sounds and the lights flash when the truck is lowered, and the different air suspension modes. To change a tire, the manual says the automatic leveling can be disabled through Uconnect (Service Mode).
From the 2026 Ram 2500/3500 Owner's Manual, Air Suspension — Operation; Uconnect Settings, Suspension; Jacking And Tire Changing (pp. 156, 182, 270), read November 17, 2026.
Towing with the air suspension
The manual says either Normal Ride Height or Alternate Trailer Height can be used when towing, and that it may not be possible to enter Alternate Trailer Height while lightly loaded. Keep the engine running while you attach a trailer so the air suspension can level properly. For all towing conditions, the manual recommends towing with TOW/HAUL mode engaged.
If you use a weight-distributing hitch, the manual's setup starts with the truck positioned to connect to the trailer (not yet connected), then measures the height from the top of the front wheel opening to the ground before (H1) and after (H2) the trailer is attached without the bars. Adjust the bars so the front fender sits about one third of the difference above H1: (H2 − H1) / 3 + H1.
For towing figures by configuration, see our Ram 3500 towing capacity page.
From the 2026 Ram 2500/3500 Owner's Manual, Towing With Air Suspension and Air Suspension System (Trailer Towing) (pp. 199-200, 208), read November 17, 2026.
Air suspension lights and messages
| Light | What it means, per the manual |
|---|---|
| Air Suspension Alternate Trailer Height Indicator | The air suspension is set to the Alternate Trailer Height setting. |
| Air Suspension Bed Lowering Mode Indicator | The Bed Lowering mode procedure is complete. |
| Air Suspension Ride Height Raising Indicator | Blinks to alert the driver that the truck is changing to a higher ride height. |
| Air Suspension Ride Height Lowering Indicator | Blinks to alert the driver that the truck is changing to a lower ride height. |
| Air Suspension Payload Protection Indicator | The maximum payload may have been exceeded, or load leveling cannot be achieved at the current ride height. Protection mode is selected and air suspension adjustment is limited due to payload. |
| Air Suspension Fault Warning Light | A fault is detected with the air suspension system. |
The manual adds that a chime sounds whenever a system error is detected, and a message appears in the instrument cluster display when conditions call for one.
From the 2026 Ram 2500/3500 Owner's Manual, Warning Lights, Indicator Lights and Instrument Cluster Display Messages (pp. 138, 141, 182), read November 17, 2026.
Air suspension service and towing the truck
The manual warns that the air suspension uses a high pressure volume of air to operate. To avoid personal injury or damage to the system, see an authorized dealer for service. See a dealer as well if normal operation does not resume after a system error.
If the truck itself is hauled on a trailer or flatbed and tied down from the body, it must first be placed in Service Mode. If that is not possible (for example, the engine will not run), the manual says the tie-downs must be fastened to the axles, not the body.
From the 2026 Ram 2500/3500 Owner's Manual, Air Suspension Warning; Towing A Disabled Vehicle (pp. 181-182, 281), read November 17, 2026.
Ram 2500 and 3500 service at Elgin CDJR
Our Mopar service department works on Ram 2500 and 3500 trucks, including the Cummins diesel and trailer-brake setups, wherever your truck was bought. Visit our Ram service center, schedule service or see our service specials.
Our service department is open Monday to Friday 7 a.m. to 7 p.m. and Saturday 7:30 a.m. to 4 p.m., and is closed Sunday. Elgin CDJR is at 1500 W. Lake St. in Streamwood. Get directions.
Ram 2500/3500 air suspension FAQ
What does the air suspension on a Ram 2500 do?
The 2026 Ram 2500/3500 owner's manual describes it as a rear leveling ride height system whose main purpose is to keep the truck's rear ride height level, with two selectable heights.
What is Alternate Trailer Height on a Ram 2500 or 3500?
Per the manual, Alternate Trailer Height lowers the truck approximately 1 inch (25 mm) for a level truck, to be used as required while trailer towing. Push the ATH button once at Normal Ride Height to select it.
Why won't my Ram 3500 lower to Alternate Trailer Height?
The manual notes that most 3500 models will not lower to Alternate Trailer Height when unloaded, and that lightly loaded 3500 models lower as close to 1 inch as possible.
How do I lower the bed on a Ram 2500 with air suspension?
Bed Lowering Mode, at zero vehicle speed, lowers the rear suspension to the lowest possible height and disables the air suspension. The manual says it ends when you drive, deselect the mode or push the Alternate Trailer Height button.
Do I need Service Mode to change a tire?
The manual says Service Mode disables the automatic leveling to assist with changing a tire. It can be activated through the Uconnect settings.
What does the air suspension payload protection light mean?
Per the manual, it means the maximum payload may have been exceeded or load leveling cannot be achieved at the current ride height, so air suspension adjustment is limited.
What are your service hours?
Monday to Friday 7 a.m. to 7 p.m. and Saturday 7:30 a.m. to 4 p.m. We are closed Sunday.
Bring your Ram to Streamwood
Visit Elgin CDJR at 1500 W. Lake St. in Streamwood.
Sources
Air suspension information is from the 2026 Ram 2500/3500 owner's manual (FCA US LLC), read November 17, 2026. Equipment varies by truck and model year; follow your own owner's manual. Our address, service hours and service list are from our own website, checked the same day.
- 2026 Ram 2500/3500 Owner's Manual: Air Suspension, Air Suspension Modes, Uconnect Suspension settings, Indicator and Warning Lights, Trailer Towing, Towing A Disabled Vehicle (pp. 138, 141, 156, 181-182, 199-200, 208, 270, 281), FCA US LLC via vehicleinfo.mopar.com, read November 17, 2026
- Ram service center page: Ram 2500/3500 and trailer service, service hours, address, Elgin CDJR, read November 17, 2026