Ram 2500 and 3500 · Elgin CDJR · Streamwood, IL

Ram 2500/3500 Tri-Fold Tonneau Cover Guide

The 2026 Ram 2500 and 3500 can be equipped with a tri-fold tonneau cover. Here is how the 2026 Ram 2500/3500 owner's manual says to remove it, install it, lock it and clean it, and the folding mistakes that damage the cover.

Black Ram 2500 on a desert highway
Ram 2500. Illustrative photo.
3 panelsFront, center and rear panels fold onto each other
2 peopleNeeded to lift the folded cover off the truck
4 clampsFront and rear pairs clamp under the bed flange
LockableClamps take a lock through the locking hole

The short answer

The 2026 Ram 2500/3500 owner's manual says the tri-fold tonneau cover (if equipped) protects your gear and cargo. To remove it, release the rear clamps from under the cover, fold the rear and center panels onto the front panel while holding them together, clip both stowage straps, release and stow the front clamps, then lift it off with two people. To install it, push the folded cover all the way forward, clamp the front pair under the bed flange, unfold it and clamp the rear pair. Never drive with the cover in the Intermediate Position or not properly clamped.

How to remove the tri-fold tonneau cover

  1. Open the tailgate to reach the rear pair of clamps on the underside of the cover.
  2. Pull both clamp handles down to release the cover's rear panel.
  3. From the Released Position, push each clamp upward from the yellow bumper to the Stowed Position. Listen for a click that confirms it is stowed.
  4. Fold the rear panel up onto the center panel (Intermediate Position). The truck cannot be driven with the cover in this position.
  5. Fold the rear and center panels up onto the front panel (Tri-Folded Position), holding the sections together.
  6. Clip both stowage straps so the panels cannot unfold.
  7. Pull both front clamp handles down to the Released Position, then push the clamps up from the yellow bumper to the Stowed Position until they click.
  8. With two people, remove the cover.

The manual says to be sure the cover is folded completely and the stowage straps are engaged before removing it, and that damage to the cover material will result if a clamp and its clamp wire are not properly stowed. Replace a damaged clamp wire immediately.

From the 2026 Ram 2500/3500 Owner's Manual, Tri-Fold Tonneau Cover Removal (pp. 109-110), read November 17, 2026.

How to install the tri-fold tonneau cover

  1. Set the folded cover on the truck bed and push it forward against the front of the bed. It centers itself.
  2. Pull down on the first set of clamp handles to release the clamps from the Stowed Position.
  3. Push the clamp wires up and under the flange of the box (or of the RamBox rail, if equipped) to the Semi-Clamped Position.
  4. Push the clamp handles upward to the clamped position to engage the clamps.
  5. Disengage the stowage straps.
  6. Unfold the center and rear panels to the Intermediate Position, holding the sections together.
  7. Completely unfold the cover.
  8. Repeat the clamp steps (release, Semi-Clamped, clamped) for the rear pair of latches.

The manual says to always push the cover all the way forward; otherwise the clamps may not engage properly, or the cover may interfere with the electronic tailgate release (if equipped). Once clamped, make sure the clamps are not improperly attached to the bed flange.

From the 2026 Ram 2500/3500 Owner's Manual, Tri-Fold Tonneau Cover Installation (pp. 110-112), read November 17, 2026.

Locking and cleaning the cover

The tonneau cover clamps can be locked in the clamped position by placing a lock through the locking hole. For cleaning, the manual recommends Mopar Whitewall & Vinyl Top Cleaner and Mopar Leather & Vinyl Conditioner/Protectant.

From the 2026 Ram 2500/3500 Owner's Manual, Tri-Fold Tonneau Cover Installation and Cleaning (p. 112), read November 17, 2026.

Mistakes the manual warns about

MistakeWhat the manual says
Driving with the cover not installed properlyAn unsecured cover can fly off while the truck is moving, resulting in a collision, personal injury and death. It is the driver's responsibility to make sure it is properly installed.
Driving in the Intermediate PositionThe vehicle cannot be driven with the cover in this position.
Folding panels separatelyWhen folding the center and rear panels, the sections must be held together to avoid damage to the cover material.
Letting panels dropFold the panels gently. Letting them drop under their own weight is not recommended.
Unlatched folded coverThe folded cover must be latched by both front latches and both front stowage straps, or damage to the cover or vehicle may occur.
Clamps not stowedIf a clamp and clamp wire are not properly stowed, damage to the cover material will result.

From the 2026 Ram 2500/3500 Owner's Manual, Tri-Fold Tonneau Cover, Warning, Cautions and Notes (pp. 109-112), read November 17, 2026.

Ram 2500 and 3500 parts and service at Elgin CDJR

Our Mopar service department works on Ram 2500 and 3500 trucks, wherever your truck was bought. Visit our parts center or Ram service center, schedule service or see our service specials.

Our service department is open Monday to Friday 7 a.m. to 7 p.m. and Saturday 7:30 a.m. to 4 p.m., and is closed Sunday. Elgin CDJR is at 1500 W. Lake St. in Streamwood. Get directions.

Ram 2500/3500 tonneau cover FAQ

Does the Ram 2500 come with a tonneau cover?

The 2026 Ram 2500/3500 owner's manual lists a tri-fold tonneau cover as if equipped, so it depends on how the truck was built.

How do I take the tonneau cover off my Ram 2500?

Per the manual: release and stow the rear clamps, fold the rear and center panels onto the front panel, clip both stowage straps, release and stow the front clamps, then lift the cover off with two people.

Can I drive with the tonneau cover half folded?

No. The manual says the vehicle cannot be driven with the cover in the Intermediate Position, and that an unsecured cover can fly off while the truck is moving.

Does the tonneau cover work with RamBox?

The manual's installation steps say to push the clamp wires under the flange of the box, or the flange of the RamBox rail if equipped.

Can the tonneau cover be locked?

Yes. The manual says the clamps can be locked in the clamped position by placing a lock through the locking hole.

What should I clean the tonneau cover with?

The manual recommends Mopar Whitewall & Vinyl Top Cleaner and Mopar Leather & Vinyl Conditioner/Protectant.

What are your service hours?

Monday to Friday 7 a.m. to 7 p.m. and Saturday 7:30 a.m. to 4 p.m. We are closed Sunday.

Sources

Tonneau cover information is from the 2026 Ram 2500/3500 owner's manual (FCA US LLC), read November 17, 2026. Equipment varies by truck and model year; follow your own owner's manual. Our address, service hours and service list are from our own website, checked the same day.

  1. 2026 Ram 2500/3500 Owner's Manual: Tri-Fold Tonneau Cover — If Equipped: Removal, Installation, Cleaning (pp. 108-112), FCA US LLC via vehicleinfo.mopar.com, read November 17, 2026
  2. Ram service center page: Ram 2500/3500 service, service hours, address, Elgin CDJR, read November 17, 2026