Ram 2500 and 3500 · Elgin CDJR · Streamwood, IL

Ram 2500/3500 Trailer Brake Controller Guide

Your 2026 Ram 2500 or 3500 may have a built-in trailer brake controller, the Integrated Trailer Brake Module (ITBM). Here is what its GAIN buttons and manual lever do, which trailer brake type to pick and how the 2026 Ram 2500/3500 owner's manual says to set GAIN.

White Ram 2500 crew cab towing a trailer in the desert
Ram 2500 towing. Illustrative photo.
0 to 10GAIN range, adjusted in 0.5 steps
20-25 mphSpeed for the GAIN test, traffic-free and on a dry, level surface
Over 2,000 lbTrailer brakes required above this trailer weight (907 kg)
4 typesLight Electric, Heavy Electric, Light EOH, Heavy EOH

The short answer

The 2026 Ram 2500/3500 owner's manual says the truck may have an Integrated Trailer Brake Module (ITBM) for electric and electric over hydraulic (EOH) trailer brakes. You set the GAIN from 0 (no trailer braking) to 10 with the +/- buttons, choose the trailer brake type in the instrument cluster's TRAILER TOW menu, and can apply the trailer brakes alone with the manual brake control lever. Set GAIN with the trailer hooked up, in a traffic-free area at 20 to 25 mph, until it is just below trailer wheel lockup.

The ITBM controls

ControlWhat the manual says it does
GAIN adjustment buttons (+/-)Adjust the brake control power output to the trailer brakes in 0.5 increments. GAIN can be increased to a maximum of 10 or decreased to a minimum of 0 (no trailer braking).
GAIN settingSets the trailer brake control for the specific towing condition. Change it as towing conditions change, including trailer load, vehicle load, road conditions and weather.
Manual brake control leverSlide it to the left to power the trailer's electric brakes independent of the truck's brakes. If the lever and the brake pedal are used at the same time, the greater of the two inputs sets the power sent to the trailer brakes.
Stop lampsWith the brake pedal, both the trailer and truck stop lamps come on. With only the manual lever, only the trailer stop lamps come on.

The manual notes the module was designed and verified with electric trailer brakes and new electric over hydraulic systems, and that some previous EOH systems may not be compatible with the ITBM.

From the 2026 Ram 2500/3500 Owner's Manual, Integrated Trailer Brake Module (ITBM) — If Equipped (p. 205), read November 17, 2026.

Which trailer brake type to choose

SelectionType of trailer brakesSuggested load
Light ElectricElectric trailer brakesUnder 10,000 lb (4,536 kg)
Heavy ElectricElectric trailer brakesAbove 10,000 lb (4,536 kg)
Light EOHElectric over hydraulic trailer brakesUnder 10,000 lb (4,536 kg)
Heavy EOHElectric over hydraulic trailer brakesAbove 10,000 lb (4,536 kg)

The manual says the suggested selection may change depending on your preference for braking performance, and that the condition of the trailer brakes, driving and the road may also affect the selection. On trucks with Blind Spot Monitoring, a cluster pop-up asks you to select a trailer type when a trailer brake signal is detected (no pop-up appears if the trailer connection status has not changed). Choosing Gooseneck/5th Wheel disables Blind Spot Monitoring, and with no selection it stays on until you choose.

From the 2026 Ram 2500/3500 Owner's Manual, Integrated Trailer Brake Module, Type of Trailer Brakes; Instrument Cluster Display, Trailer Tow (pp. 130, 206), read November 17, 2026.

How to set the GAIN, step by step

The manual says to do this only in a traffic-free environment at about 20 to 25 mph (30 to 40 km/h).

  1. Make sure the trailer brakes are in good working condition, functioning normally and properly adjusted. See your trailer dealer if necessary.
  2. Hook up the trailer and make the electrical connections according to the trailer manufacturer's instructions.
  3. When a trailer with electric or EOH brakes is plugged in, the trailer connected message should appear in the instrument cluster display and the GAIN setting will illuminate. If the ITBM does not recognize the connection, braking functions will not be available.
  4. Push the UP or DOWN button on the steering wheel until TRAILER TOW appears on the screen, then push the RIGHT arrow to enter it.
  5. Push the UP or DOWN buttons until Trailer Brake Type appears, push the RIGHT arrow, then use UP or DOWN to select the proper type.
  6. In a traffic-free environment, tow the trailer on a dry, level surface at 20 to 25 mph (30 to 40 km/h) and squeeze the manual brake control lever completely.
  7. If the trailer wheels lock up (squealing tires), reduce the GAIN. If the trailer wheels turn freely, increase the GAIN.
  8. Repeat the last two steps until the GAIN is just below trailer wheel lockup. With a heavier trailer, lockup may not be reachable even at the maximum GAIN of 10.

From the 2026 Ram 2500/3500 Owner's Manual, Integrated Trailer Brake Module, Adjusting GAIN (p. 206), read November 17, 2026.

Trailer brake rules from the manual

  • Trailer brakes are recommended for trailers over 1,000 lb (453 kg) and required for trailers over 2,000 lb (907 kg).
  • An electronically actuated trailer brake controller is required for a trailer with electronically actuated brakes. A trailer with a hydraulic surge actuated brake system does not need an electronic brake controller.
  • Do not connect trailer brakes to the truck's hydraulic brake lines, and do not interconnect the truck's hydraulic brake or vacuum system with the trailer's.
  • Towing any trailer increases stopping distance, so allow extra space to the vehicle in front.
  • Connecting a trailer that is not compatible with the ITBM may result in reduced or complete loss of trailer braking.

For towing figures by configuration, see our Ram 3500 towing capacity page. Driving a half-ton? See our Ram 1500 trailer brake controller guide.

From the 2026 Ram 2500/3500 Owner's Manual, Towing Requirements — Trailer Brakes; Integrated Trailer Brake Module (pp. 205-206), read November 17, 2026.

Trailer brake lights and messages

IndicatorWhat it means
Trailer Brake Status Indicator LightShows the trailer electrical connection status.
Trailer Brake Disconnected Warning Light, onThe trailer brake has been disconnected.
Trailer Brake Disconnected Warning Light, flashingA fault was detected in the trailer wiring or the ITBM.
No trailer connectedWith no electrical connection after the ignition is turned on, pushing a GAIN button or sliding the manual lever shows the GAIN setting for 10 seconds, and the disconnected light is not displayed.
Display messagesMessages with a single chime appear when a malfunction is found in the trailer connection, the trailer brake control or the trailer.

From the 2026 Ram 2500/3500 Owner's Manual, Red Warning Lights; Integrated Trailer Brake Module, Display Messages (pp. 138, 205-206), read November 17, 2026.

Ram 2500 and 3500 service at Elgin CDJR

Our Mopar service department works on Ram 2500 and 3500 trucks, wherever your truck was bought. Visit our Ram service center, schedule service or see our service specials.

Our service department is open Monday to Friday 7 a.m. to 7 p.m. and Saturday 7:30 a.m. to 4 p.m., and is closed Sunday. Elgin CDJR is at 1500 W. Lake St. in Streamwood. Get directions.

Ram 2500/3500 trailer brake controller FAQ

Does the Ram 2500 have a built-in trailer brake controller?

The 2026 Ram 2500/3500 owner's manual says the truck may have an Integrated Trailer Brake Module (ITBM) for electric and electric over hydraulic trailer brakes. It is listed as if equipped.

What should I set the Ram trailer brake gain to?

There is no single number. The manual says to set GAIN to a point just below trailer wheel lockup, found by squeezing the manual lever at 20 to 25 mph on a dry, level, traffic-free surface, and to change it as towing conditions change.

What is the highest gain setting?

GAIN can be set from 0 (no trailer braking) to a maximum of 10, in 0.5 increments.

Light or heavy electric: which should I pick?

The manual suggests Light Electric for electric-brake trailers under 10,000 lb and Heavy Electric above 10,000 lb, with the same split for Light and Heavy EOH. It says the choice can change with your braking preference and trailer and road conditions.

Does a trailer with surge brakes need the controller?

No. The manual says an electronic brake controller is not required when towing a trailer with a hydraulic surge actuated brake system.

Why is my trailer brake light flashing?

Per the manual, a flashing Trailer Brake Disconnected Warning Light means a fault was detected in the trailer wiring or the ITBM.

What are your service hours?

Monday to Friday 7 a.m. to 7 p.m. and Saturday 7:30 a.m. to 4 p.m. We are closed Sunday.

Sources

Trailer brake controller information is from the 2026 Ram 2500/3500 owner's manual (FCA US LLC), read November 17, 2026. Equipment varies by truck and model year; follow your own owner's manual and your trailer maker's instructions. Our address, service hours and service list are from our own website, checked the same day.

  1. 2026 Ram 2500/3500 Owner's Manual: Instrument Cluster Display, Trailer Tow; Red Warning Lights; Towing Requirements — Trailer Brakes; Integrated Trailer Brake Module (pp. 130, 138, 205-206), FCA US LLC via vehicleinfo.mopar.com, read November 17, 2026
  2. Ram service center page: Ram 2500/3500 service, service hours, address, Elgin CDJR, read November 17, 2026