Ram 2500 Power Wagon · Elgin CDJR · Streamwood, IL

Ram Power Wagon Winch Guide

A winch-equipped Ram 2500 Power Wagon carries an electric recovery winch with synthetic rope. Here is how the 2026 Ram 2500/3500 owner's manual says to tension the rope, run a recovery, rewind and stay safe, plus how the Power Wagon's sway bar disconnect works.

Ram 2500 driving through deep snow
Ram 2500 in snow. Illustrative photo.
1,000 lbMinimum tension when first winding the rope (454 kg)
10 wrapsNever winch with fewer wraps of rope on the drum
30 secondsWinch pause if the low-voltage interrupt trips
18 mphNever drive above this with the sway bar disconnected (29 km/h)

The short answer

The 2026 Ram 2500/3500 owner's manual describes the winch (if equipped) as an electric vehicle recovery winch powered by the truck's charging system, with synthetic rope, a drum with an integral brake, a clutch lever for free spooling and a plug-in remote control. Before first use, tension the rope with at least 1,000 lb (454 kg) of load. In a recovery, wear gloves, free-spool the rope to a secure anchor, lock the clutch, connect the remote and winch slowly and steadily, keeping everyone out of the no people zones.

The Power Wagon winch parts

PartWhat the manual says
Remote controlPowers the winch in, out and stop. Push the toggle down to power in and up to power out; the winch stops with the switch in the center position.
MotorPowered by the vehicle charging system.
Remote socketOn the bumper assembly; lets the remote control attach to the control pack.
Drum with integral brakeStores the rope and transmits force to it. The integral brake stops drum rotation if the motor is stopped.
Synthetic ropeFlexible, lightweight and floats. Use the supplied abrasion sleeve with it at all times.
Clutch leverDisconnects the drum from the motor so the rope can be pulled out by hand (free spooling).
Hawse fairleadGuides the synthetic rope and minimizes damage to it.

The manual lists gloves, a snatch block, clevis/D-shackles and a tree trunk protector as accessories needed to attach to anchors, change the direction of pull and winch safely. It also says not to operate the winch without reading and understanding the complete winch owner's manual.

From the 2026 Ram 2500/3500 Owner's Manual, Winch Usage — If Equipped (pp. 185-186), read November 17, 2026.

Tensioning the winch rope

The manual says the rope must be properly tensioned before use:

  1. Un-spool the rope, leaving five wraps on the winch drum.
  2. Attach the hook to a suitable anchor point that will withstand the load.
  3. Apply at least 1,000 lb (454 kg) of tension to the rope while winding it, making sure it winds neatly and does not pile up on one side of the drum.

The rope must spool onto the drum in the direction shown on the drum rotation decal. If the low-voltage interrupt trips because charging voltage drops too low, the winch will not power in or out for 30 seconds; run the truck at high idle for a few minutes to let the charging system recover before winching again.

From the 2026 Ram 2500/3500 Owner's Manual, Winch Usage — Tensioning The Winch Rope; Low Voltage Interrupt (p. 185), read November 17, 2026.

How to recover a vehicle with the winch

A condensed version of the manual's vehicle recovery steps:

  1. Inspect the winch, mount and rope. Do not use the winch if the mount is loose or the rope shows excessive wear, fraying or damage.
  2. Put on gloves.
  3. Disengage the clutch with the clutch lever to free-spool the drum. The manual notes free spooling conserves battery power.
  4. Free the hook from its anchor point and attach the hook strap.
  5. Pull out enough rope to reach your anchor, holding the hook strap so you do not lose the end.
  6. Secure a tree trunk protector or choker chain around the anchor, then attach the clevis/D-shackle through the hook (tighten, then back off 1/2 turn).
  7. Lock the clutch by rotating the clutch lever to engage, making sure it is fully engaged.
  8. Connect the remote control to the winch control box on the front fascia/bumper. If you control the winch from inside the truck, pass the remote through a window so the cord is not pinched in the door.
  9. Slowly wind in the rope until no slack remains, then stand well clear and never step over it. If you plan to lay a heavy blanket over the rope, midway to the anchor, do it before the rope is under tension.
  10. Check the anchor and make sure the rope is wound neatly on the drum.
  11. Establish no people zones: never behind or in front of the vehicle and never near the rope or snatch block.
  12. With the engine on, winch slowly and steadily. The winched vehicle can be slowly driven while it is pulled. Continue until it is on stable ground.
  13. Secure the vehicle's brakes, shift to PARK, release rope tension, disconnect the rope from the anchor and rewind it evenly, walking the rope in.
  14. Store the hook on the most outboard loop of the hawse fairlead, disconnect the remote and store it in a clean, dry place, and cap the solenoid plug-in.

If no natural anchor is available when you recover another vehicle, the manual says your truck becomes the anchor: put the transmission in NEUTRAL, apply the hand brake and block its wheels. An anchor as far away as possible gives the winch its greatest pulling power.

From the 2026 Ram 2500/3500 Owner's Manual, Vehicle Recovery Using The Winch (pp. 187-190), read November 17, 2026.

Winch safety rules from the manual

  • Never use the winch as a hoist or to move people, and never exceed the winch or rope rated capacity.
  • Never touch the rope or hook while it is under tension or load, or while someone else is at the control switch.
  • Never engage or disengage the clutch while the winch is under load, the rope is in tension or the drum is moving.
  • Never winch with fewer than 10 wraps of synthetic rope around the drum.
  • Never wrap the synthetic rope back onto itself; use a choker chain, wire choker rope or tree trunk protector on the anchor.
  • Never attach a recovery strap to the winch hook to lengthen a pull or to tow a vehicle, and never use bungee or kinetic straps.
  • Never power the hook through the fairlead, and never put your fingers inside the hook area while powering in.
  • Disconnect the remote when not in use, and never leave it plugged in while free spooling, rigging or sitting idle.
  • Avoid overheating the motor: on extended pulls, stop at reasonable intervals to let it cool. Use the switch intermittently to take up slack and avoid shock loads.

From the 2026 Ram 2500/3500 Owner's Manual, Operating Your Winch, Warnings; Using The Remote Control (pp. 186-190), read November 17, 2026.

Changing direction and increasing pulling power

The manual says every winching operation should have a straight line from the winch to the object being pulled. A snatch block secured directly in front of the truck lets you change the pulling direction while the rope still winds properly onto the drum. Because pulling power drops with each layer of rope on the drum, a snatch block can also be used to double line the rope: it puts fewer layers on the drum and increases pulling power.

From the 2026 Ram 2500/3500 Owner's Manual, Rigging Techniques; How To Change The Pulling Direction; Increasing Pulling Power (pp. 190-191), read November 17, 2026.

Power Wagon sway bar disconnect

The manual says the Power Wagon has an electronic disconnecting front stabilizer/sway bar that allows greater front suspension travel off-road. To disconnect it, shift to 4WD HIGH or 4WD LOW and push the SWAY BAR switch below the instrument panel. The Sway Bar Indicator Light flashes until the bar is fully disconnected and is lit while the bar is disconnected. Push the button again to return to On-Road mode.

  • Do not disconnect the bar and drive on hard surfaced roads or above 18 mph (29 km/h). The system will attempt to reconnect the bar above 18 mph, and once speed drops below 14 mph (22 km/h) it will attempt to return to Off-Road mode.
  • The bar may be torque locked by left and right suspension height differences. Driving onto level ground or rocking the truck side to side may be needed for it to disconnect or reconnect.
  • If the bar will not return to On-Road mode, do not drive over 18 mph and contact your local service center.

From the 2026 Ram 2500/3500 Owner's Manual, Stabilizer/Sway Bar System — Power Wagon Only (pp. 191-192), read November 17, 2026.

For Power Wagon equipment and options, see our Ram 2500 Power Wagon page.

Ram Power Wagon service at Elgin CDJR

Our Mopar service department works on Ram 2500 and 3500 trucks, wherever your truck was bought. Visit our Ram service center, schedule service or see our service specials.

Our service department is open Monday to Friday 7 a.m. to 7 p.m. and Saturday 7:30 a.m. to 4 p.m., and is closed Sunday. Elgin CDJR is at 1500 W. Lake St. in Streamwood. Get directions.

Ram Power Wagon winch FAQ

How do I free spool the Power Wagon winch?

Per the 2026 Ram 2500/3500 owner's manual, rotate the clutch lever on the winch to disengage the clutch. That lets you pull the rope out by hand. Never engage or disengage the clutch under load or with the drum moving.

Where does the winch remote plug in?

The manual says to connect the remote control to the winch control box on the front fascia/bumper, and to disconnect it when not in use.

Why did my winch stop for 30 seconds?

The winch has a low-voltage interrupt. If charging voltage drops too low it will not power in or out for 30 seconds. Run the truck at high idle for a few minutes before winching again.

How many wraps should stay on the drum?

The manual says never winch with fewer than 10 wraps of synthetic rope around the drum. When first tensioning the rope, leave five wraps on the drum and apply at least 1,000 lb of tension while winding.

Can I use a kinetic strap with the winch?

No. The manual says never use bungee or kinetic straps, and never attach a recovery strap to the winch hook to lengthen a pull or tow a vehicle.

How fast can I drive with the sway bar disconnected?

The manual says do not drive on hard surfaced roads or above 18 mph (29 km/h) with the stabilizer bar disconnected. The system tries to reconnect it above 18 mph.

What are your service hours?

Monday to Friday 7 a.m. to 7 p.m. and Saturday 7:30 a.m. to 4 p.m. We are closed Sunday.

Sources

Winch and sway bar information is from the 2026 Ram 2500/3500 owner's manual (FCA US LLC), read November 17, 2026. Equipment varies by truck and model year; follow your own owner's manual and the winch maker's guide. Our address, service hours and service list are from our own website, checked the same day.

  1. 2026 Ram 2500/3500 Owner's Manual: Winch Usage; Vehicle Recovery Using The Winch; Rigging Techniques; Stabilizer/Sway Bar System — Power Wagon Only (pp. 185-192), FCA US LLC via vehicleinfo.mopar.com, read November 17, 2026
  2. Ram service center page: Ram 2500/3500 service, service hours, address, Elgin CDJR, read November 17, 2026
  3. Ram 2500 Power Wagon page, Elgin CDJR, read November 17, 2026